I installed the Lockhart Phillips Short Stalk III (Black/Amber) Signals in March 2001.  It took me about 2 hours to get the signals installed and working properly.  The only tool required was a phillips screwdriver. 

- Easy install right into the existing signal mounting points.
- The Short Stalk III's combined with Flush Mount IVs caused a fast flash rate.
- Replacing both sets of (large) stock bulbs with the smaller LP bulbs created a change in the circuit current.
- EXTENSIVE research by my uncle Kris & myself (with help from Ohm's Law) showed which resistor would work without creating too much heat.
- I placed a 50ohm 10watt resistor in parallel with each bulb to correct the flash rate.
- Radio Shack has the resistors (271-333) for about a buck.
- After wrapping each assembly with electrical tape, I secured the wires using the cable stays located in the trunk.
- Very neat final product.

Stock Number:  122-9850

This site was last updated 06/16/06