I installed the Competition Werkes Fender Eliminator Kit in March 2001.  It took me about 4 hours to complete.  I used a dremel tool with a cutting bit, a hand saw and a utility knife to trim the stock plastic. 

- I retyped the instructions in Word so I could READ them.
- I removed the tailsection AND exhaust can to prevent scratches & to provide maximum access.
- Take your time cutting. You can always cut more, but you can't put it back!
- Utilize online resources (manufacturer's website, forums, etc.)

Stock Number:  1H929

This site was last updated 06/16/06